Hydroion Magnetic Device

Hydroion deploys non-chemical technology to avoid scale on the inner surface of the water flowing pipes and  also other surfaces where water flows. Typical advantages of Hydroion in idustrial application are as below:

In short every difficulty in maintaining equipment and plant because of scales in inner pipes are eliminated. Consequently there is substantial saving in cost. An example of cost saving can be provided as below:

Cad Designs

How It Works

HYDROION is from a stainless steel body to protect itself from atmospheric corrosion. Unlike other typical magentic water treatment device, it has in-built catalatyzer, which not only enhances the treatment process but also protects the magnet from electrical and electronic smog. The water has high level of energy, with reduces PH value and higher concentration of CO2 to increase the level of carbonic acid. The water passing through it is subjected to following equation.

CaHCo3 ----- Ca Co3 + Co2+ H2o

As per the laboratory test it has been found that the magnetic treatment allows the carbon dioxide (CO2) to remain dissolved in water. With the increased solubility of CO2, Ph is lowered, which also accelerates the de-scaling , the end product of which is argonite-a soft hydrated form of calcite obtained through its increased hydration It is now mainataind in a ‘colloidal’ suspension (microscopic solution) ready to be mechanically flushed from the attached surface and not sticking inside the pipes or hot water heater, instead its beneficial effect staying in drinking water.

The micro-fine minerals are prevented from crystallizing into a rock hard energy insulating scale of calcite on inside of water pipes and tubes.

Cost Saving

From energy saving : The scale in the pipe reduces the performance of the heat transfer, resulting in loss of energy and extra cost. Hydroion keeps the inside of pipe scale free and efficiency of heat transfer is increased. This is how it saves energy. Incase of Boiler, it reduces the Blow down time and saves energy. As Hydroion not only prevents scale , it also boils water faster and so in case of Boiler it is very effective in energy saving.

From Maintenance saving: The factors those are to be considered are as below:

• regular salt charging in chemical treatment, cost of the person, chemical etc. This is not in case of Hydroion.
• Inspite of daily routine maintenance, there is corrosion in the pipes. The cost of replacement of pipes is very high. This is not in case of Hydroion.

Application Areas

Chilling Water - ( Ref: drawing of water cooling plant for chilling water with Hydroion)

Here water is cooled through refrigeration system, end application of the water could be for cooling the oil of Hydraulic presses, or cooling the pipes in heat treatment plant, or welding machines. Some pictures of application in industry . The scale that occurs in the inside of the pipe reduces the heat transfer efficiency and cost extra energy for frequent running of the pump. A thumb rule chart on reduction of heat-transfer efficiency can be as below:

To avoid the scaling inside the pipe most practiced system is to treat the water through Ion-Exchange where normal salts have to be charged on regular basis. The dis-advantages of such system are:

• It discharges water which pollutes the environment
• The plant has to be continuously monitored
• Routine charging of salts
• The pipe can corrode over the years from sodium deposits
• Costly maintenence

Eco Crystal proviodes a non-chemical solution to this problem, it does not add any chemical to water nor removes any.

AIR CONDITIONING UNIT WITH THE CONDENSER - Hydroion is a excellent device to keep the inside of the water cooled condenser pipes scale free, which keeps the airconditioning system trouble free and saves energy. The thick scale inside the condenser pipes reduces the heat transfer efficiency. Also over the years pipes get corroded and require expensive maintenance.Most condensers have a 10 degree rise in water temperature from the inlet to oulet, so 85 degrees inlet should mean 95 degrees out. This is only under full load, when the water-cooled condenser is only working. At half load, there will be a 5 degree rise in condenser temperature.

BOILER - Hydroion not only saves energy but also reduces the CO2 emmission from the boiler system, and also reduces the need of chemical which pollutes the environment. The device:

• keeps the inside of the water pipe scale free
• keeps the heating coil scale free (in case of electric heating)
• It heats water faster, 10-15%
• It reduces the PH value of water
• It redces the blow down time

Recoverable heat from Boiler Blow down

Hydroin reduces the blow down and thus the saving. In nut shell Hydroion when installed in the boiler system, it imparts the following major benefits, which are of concern today due to stringent demand for saving environment and energy.

• COST EFFECTIVE WATER TREATMENT
• ENERGY SAVINGS
• WATER CONSERVATION
• POLLUTION PREVENTION

A strong point for using Hydroion in Boiler systems is how much a customer will be paying for ‘Unpriced services ‘ such as testing, lab services, on-site monitoring, analytical equipment,. Reagents etc FOR DOMESTIC USE - Hydroion offers execllent benefit to people when it is installed at the entry point of the water tank. It can be just mounted before the big water tank of multistoreyed building and also for individual houses. It renders the following specific advantages:

• Inside of pipes remain scale free
• Never one will find reddish water coming out of water tank
• Saving in detergent
• Saving in cooking gas or electricity as Hydroion helps to boils water faster
• Water is tasty and healthy, however has to filtered for bacteria and other undesirable element

Specification:

• Stainless steel body
• Clamp-on to steel or plastic pipes
• Magnetic device complete with not-contact catalyzer

Benefits:

• Improves heat transfer energy on water chiilling plant and air conditioning plant with water circulating
• Aabsolutely scale free pipes
• Excellent performance on heat treament furnace, plastic moulding machine, die casting machine, and other equipment with circulating water.
• Excellent performance in residences be it apartment, villa or big housing complex when installed at the water inlet pipe, keeps the pipe scale free
• Excellent performance in ready mix concrete machine to increase the cement strength and saves water.

Prices:

• 1 inch pipe ... £174.00 exclusive of taxes and shipping costs.
• 2 inch pipe ... £362.50 exclusive of taxes and shipping costs.
• 3 inch pipe ... £507.50 exclusive of taxes and shipping costs.
• 4 inch pipe … £616.25 exclusive of any taxes and shipping costs.
• 6 inch pipe ... £1450.00 exclusive of any taxes and shipping costs.